DataCard SP75 Plus Guía de instalación descargar pdf (Pagina 46)

Page 41

1 With “Configuration” displayed on line 1, press the Up or Down Arrow key if needed

to display “DHCP/Static IP” on line 2.

2 Press the Enter key. The current address mode value is displayed on line 2.

3 Press the Up or Down Arrow key to display the address mode you want. Possible

values are DHCP and Static IP.

4 Press the Enter key.

5 The next step depends on which address mode you have chosen:

— If you have chosen DHCP, “Apply/Restart” appears on line 2. Press the Enter

key to restart the printer. After the printer restarts, see "View the Network

Address Mode, IP Addresses, and MAC Address" on page 35 to retrieve the IP

address and other data.

— If you have chosen Static IP, “IP Address” appears on line 2. See "Set the IP Address, Subnet Mask, and

Gateway Address" on page 42 for the steps to follow.

• You must set the IP address, subnet mask, and gateway IP address for the printer. The printer will

restart after you enter these values.

— If you have used the DHCP/Static IP menu selection but did not actually change the address mode, the

next menu item appears on line 2. Press the Up or Down Arrow key to display “Exit” on line 2. Press the

Enter key repeatedly to return to the “Printer Ready” display.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 135 136

Sin comentarios

DataCard SP75 Plus Guía de instalación Pagina 46