DataCard LM200 Guía de instalación descargar pdf (Pagina 17)

SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide 9

Network Connection

Whenalocalnetworkisavailable,boththecardprinterandthePCcanbeconnectedtothe

network.Whenanetworkconnectionisused,youcanprintcardsfromanyPCconnectedtothat

network.

EachPCmusthavethedesignsoftwareusedtocreateandprintcards,musthave

theSR‐CP

printerdriverandStatusMonitorinstalled,andmustbeconnectedtothesamenetworkasthe

printer(s).

Network Installation Overview

Performthesestepstoinstallyourcardprintertoanetwork.RefertoChapters2,4,5,and6of

thismanualfordetailedinstructions.

1. (Optional)InstallIDsoftware,suchasDatacard

IDWorks

identificationsoftware,ont othe

PCthatwillbeusedtodesignandprintcards.

2. Physicallyinstalltheprinterandoptionallaminator:

a. Connectthelaminator(ifused)totheprinter.

b. Installthecardhopper.

Remember,useaUSBconnectionifyourcardprintercontainsanoptionalsmartcard

reader.NetworkconnectionforasmartcardisnotsupportedbytheSR200&SR300

printers.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 93 94

Sin comentarios

DataCard LM200 Guía de instalación Pagina 17