DataCard LM200 Guía de usuario descargar pdf (Pagina 24)

14 Using the Printer and Laminator

Replacing the Card Hopper

Iftheentirecardhopperhasbeenremovedfromtheprinter,

reinstallitbeforeusingtheprinter.

1. Insertthehooksonthecardhopperintotheslotsinthe

receptacle.

2. Slidethecardhopperdownuntilitclicksintoplace.

Adjusting Card Thickness

Fromthefactory ,theprinterissettousecards0.030inch(0.75mm)thick.Followthesestepsto

settheprintertousecardsofadifferentthickness.

1. Removethecardhopper,asdescribedabove.

2. Turnthehoppersothatthesilverdialfacesyou.

3. Useapointeditemsuch

asapentoslidethedial:

 Counterclockwisetoprintthinnercards.

 Clockwisetoprintthickercards.

 Asettingof1.0mmcorrespondstocards0.040inchthick.

 Asettingof0.75mmcorrespondstocards0.030inchthick.

 Asettingof0.5mmcorrespondstocards0.020inchthick.

 Asettingof0.25mmcorrespondstocards0.010inchthick.

4. Replacethecardhopper.(See“ReplacingtheCardHopper”above.)

5. SetthecardthicknessontheStatusMonitor.Referto“MediaSettingTab”onpage 44.

6. Testthenewsettingwithseveralcardstomakesurethattheprinterpicks

onlyonecardata

time.

Contactyourdealerorserviceproviderbeforeusing0.010inch(0.25mm)thickcards.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 137 138

Sin comentarios

DataCard LM200 Guía de usuario Pagina 24