DataCard SR300 Manual de usuario descargar pdf (Pagina 9)

SR200 & SR300 Printer SDK Guide

Page 5

Process Flow to Issue the Card

First, use the Scan Printer function to obtain the Slot number and ID of the printer.

When you have these values, you can use them to send commands to the printer.

The following diagram shows the typical flow for card processing.

You can use a different order if needed by your card design.

Scan Printer

Image Out

Card Load *

Retransfer & Eject

IC Control

Card Move

MG Writing

Card Move

Retransfer & Turn *

Image Out

Print *

Commands marked * should set

the Immediate flag to On so

mechanical and data actions

happen in parallel. With

Immediate set to On, the

command ends after the

command is accepted by the

printer so the software can take

the next action, such as sending

the image.

Each group of items inside a

dashed-line box is optional.

The diagram shows some but

not all card positioning

commands. You must position

the card at the correct location

for each command.

If errors occur before Retransfer

and Eject, the card is

discharged from the Reject

Card Slot. Only the Retransfer

command ejects the card to the

card stacker (or laminator, if

used).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 75 76

Sin comentarios

DataCard SR300 Manual de usuario Pagina 9