DataCard CP60 Guía de instalación descargar pdf (Pagina 101)

Page 96

MS-01435 No Mag Stripe

The magnetic stripe module is not installed or detected.

Possible Cause 1: Magnetic stripe data was sent to the printer and a

magnetic stripe module is not installed.

Solution 1: Remove the magnetic stripe components of the card design.

Print cards without sending magnetic stripe data to the printer.

Possible Cause 2: The magnetic stripe module is not communicating with

the rest of the printer.

Solution 2: Check the printer to see whether a magnetic stripe module is

included in the printer. If it is, power the printer off and on (disconnect the

power cord from the printer power supply and then connect it again) so the

printer can detect the module when the printer powers up.

If a magnetic stripe module is part of the printer and you receive this

message, contact your service provider for assistance.

Sin comentarios

DataCard CP60 Guía de instalación Pagina 101