DataCard RL90 Guía de usuario descargar pdf (Pagina 59)

Laminator error recovery

RP90 and RL90 User Guide 53

Heater Err The heater temperature

does not increase.

Check that the voltage inlet switch, located on the

back of the laminator, is in the proper position for the

input voltage. Contact your service provider if this

does not correct the condition.

HR Overheat Heat roller temperature is

too high.

Turn the unit off and contact your service provider

before powering back on.

Temp Sensor The heat roller

temperature sensor is not

working.

Turn the unit off and contact your service provider

before powering back on.

Memory Err There is an internal

memory error.

Turn the unit off and contact your service provider

before powering back on.

Set Temp Err There is an error with the

heat temperature setting.

Turn the unit off and contact your service provider

before powering back on.

R. Encoder Err Rotary encoder error. Turn the unit off and contact your service provider

before powering back on.

Overheat The temperature inside the

unit is too high.

Turn the unit off and contact your service provider

before powering back on.

PRT. Communicate Communication error with

the printer.

Check that the laminator cable is connected securely

to the printer.

Turn the printer and laminator off, and then back on to

recycle the power.

Film Exchanged? The patch or topcoat

material was changed

while the laminator was

turned off.

Press the RESET/ and then the ENTER key to

initialize the patch or topcoat material.

LCD Message Possible Cause Solution

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 74 75

Comentarios a estos manuales

Sin comentarios