DataCard LM200 Guía de usuario descargar pdf (Pagina 41)

SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide 35

— Number of Retry, which sets the maximum number of retries when writing or

reading magnetic stripe data fails. Default value is 1.

— ISO Mode, which sets the power used by the magnetic card encoder. The

default is Hi-Co.

• A control to enable or disable the buzzer.

• A control to set the display contrast.

• A control to set the display mode.

• A control to change the display counter.

• Controls to set power saving, which reduces the temperature of the retransfer heat

roller after the printer is not used for the chosen time. If a laminator is installed, this

setting also affects the laminator heat roller. The roller returns to operating

temperature when the next card is printed.

— The interval to wait until power saving takes effect.

Choose from OFF for network

operation or select from 5 to 60 minutes in 5 to15 minute increments (for a USB

connection). The default is OFF

— Setting HR Control to Enable can add to the useful life of the retransfer heat

roller. The default is Enable.

— “Sleeping” appears on the LCD display. To cancel power save mode, press

Reset and then the Enter key. The printer uses one set of supplies.

• The Update button updates the printer settings.

• The Refresh button displays the printer settings.

Retransfer tab

The Retransfer tab shows:

• A front-side matrix and a back-side matrix for

setting the retransfer speed and temperature.

Click a square to choose the setting. Click the

Update button to send the settings to the

printer.

• The card type, set on the Media Setting tab.

• The Refresh button which displays the current

printer data.

• Speed settings for transferring UV ink to the

card.

Tips for success

• The transfer power to the card gets stronger

towards the upper right, but the card becomes more distorted due to the heat.

• Changing the retransfer temperature on one card side also affects the other side.

• The recommended range of values changes with the Card Type setting.

• Make sample cards to verify settings before using new settings.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 108 109

Sin comentarios

DataCard LM200 Guía de usuario Pagina 41