DataCard UltraGrafix Select Manual de instalación descargar pdf (Pagina 158)

146 Production Options Setup

Settings Tab

Auto Remake Mode:

• Off—The system will not attempt auto remakes.

• Preserve Data Order—Entire Machine—The system will remake the card

when it fails in any module.

• Preserve Data Order for Encoding Rejects Only—When an encoding error

occurs, the system will eject the upstream cards and remake beginning with

the rejected card.

• Preserve Data Order for Encoding and Smart Card Rejects Only—The

system will remake cards with magnetic stripe encoding or smart card

encoding errors while preserving the data order.

Consecutive Error Threshold - This number denotes how many sequential errors

on the same module or coupler are allowed before the system notifies the

operator and stops the system, stating it had x number of consecutive errors on

the same module or coupler. Each error is displayed to the operator but the

system does not stop until it reaches this threshold.

Card Stock Verification/Verification QA - Allows independent management of

error expectations for card stock identification and quality assurance. Select the

checkboxes to enable and then enter the number of errors allowed for each

scenario.

Pre-Embossed - Describes the profile of the card to the system for better picking.

Select True or False.

Laser Gang Mode - Select to turn Laser Gang Mode on or off. When more than

one Laser module is present in a system, Laser Gang Mode can be used to

optimize production speed.

Cleaning Cycle - Enter the number of cards to be processed between cleaning

cycles. The default is 50. Set a lower number if the site has a dusty environment.

Stripe Erase on Error - Select to bring the card back to be erased when a magnetic

stripe encoding error occurs.

Magstripe Retry Mode - Select Re-Read or Re-Write to make the system retry on

a magnetic stripe read or write error. Select Off (default) to disable.

Magstripe Retry Count - Enter the number of times the magstripe module will

attempt to encode the card before it is rejected.

Reject Policy:

• None—Proceeds as normal, card will be rejected.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 321 322

Sin comentarios

DataCard UltraGrafix Select Manual de instalación Pagina 158