DataCard UltraGrafix Select Manual de instalación descargar pdf (Pagina 17)

Maxsys and MX Series Software Administrator’s Guide 5

Lower Status Bar

The lower status bar has program tabs on the left side that display all open

applications. In the example shown below, the Production interface, Event Log

Viewer, and Job Setup applications are currently open. Clicking on a Tab will

bring that application window to the top.

Enabling the Syntera Interface

For sites that use both Maxsys/MX Series and the Datacard® Syntera®

Manufacturing Efficiency System, the Syntera system is integrated into the

Maxsys/MX Series Production application. This allows Syntera jobs to be run on

a Maxsys/MX Series machine if needed.

To enable or disable the Syntera interface, follow these steps:

1. Select Ap

plications | Utilities | Diagnostics.

2. Select Controller in the left pane.

3. Under the

Controller Configuration Editor tab, double-click System in the

list to expand it, and then expand Syntera Interface.

4. Under Syntera Interface, select

Syntera Interface Enabled and then set the

value to true on the top bar by double-clicking the false value and selecting the

option button in the pop-up box. (To disable the Syntera interface, reset the

value to false.)

Close and restart the program for the changes to take effect.

When Syntera is enabled, toggle between the two programs by clicking the button

on the toolbar.

Open Hood status Indicates whether it is OK to open the hood.

Audit status information Indicates whether audit data is being collected.

Indicator Description

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 321 322

Sin comentarios

DataCard UltraGrafix Select Manual de instalación Pagina 17