DataCard UltraGrafix Select Manual de instalación descargar pdf (Pagina 281)

Maxsys and MX Series Software Administrator’s Guide 269

Bitmap Settings Tab

This tab is common to all bitmapped elements.

Alignment Point The x/y coordinate (mm) to which the image is aligned.

Horizontal Pos. Horizontal alignment (left, center or right) with the

alignment point.

Vertical Pos. Vertical alignment (top, middle or bottom) with the

alignment point.

Rotation Rotation of the image (range: -180 to 180 degrees)

around the alignment point

When rotating an element, the laser line or scan

direction will also change.

Shear Adjustment for shear on either the x or y axis.

Output DPI Integer between 0 and 16000 or Auto.

Output DPI y Ability to set the resolution in y direction. Available only

when using Mode 5 (Independent y resolution). See in

“BMP Laser Details” on page 270

Crop White Space By default cropping is enabled on all sides.

Alpha Blending Select Alpha Blending to enable Alpha Channel feature.

See “Alpha Channel” on page 259.

Read Only: Bitmap

Output Size

The x/y dimensions (mm or pixels) of the bitmap.

Enhance Edge Selection of this feature uses different laser settings to

increase contrast at gray level edges, for example at a

white-to-black or black-to-white transition. It is

recommended for most types of elements containing

black and white content (few or no gray pixels).

Examples include text, barcodes, signatures, and logos.

It should not be used for portraits.

Enhance edge mode may be slower than non-

enhanced edge mode.

Note: Enhance edge is activated by default for

bitmapped text and barcodes, deactivated by default

for bitmap images.

Negative Inverts the gray levels of the image (black = white; white

= black)

1 2 ... 276 277 278 279 280 281 282 283 284 285 286 ... 321 322

Sin comentarios

DataCard UltraGrafix Select Manual de instalación Pagina 281